Industrial
Electronic Devices
ADFweb.com S.r.l.
User Manual
M-Bus / M-Bus Wireless / BACnet Slave
Document code: MN67086_ENG Revision 1.100 Page 24 of 43
S
ECTION
N
ODES
(
W
M-B
US NODES
):
In the field “
Manufacturer ID
” it is necessary to
define the Manufacturer ID of the wM-Bus node.
In the field “
Address
” it is necessary to define the
ID of the wM-Bus node.
If the field “
Version
” it is necessary to define the
version of the wM-Bus node.
In the field “
Device Type
” it is possible to define
the Type of the wM-Bus node.
The field “
Key Enable
” is used to decode the M-
Bus frame sent by the wM-Bus node if it uses
encrypted communication. In the following 16
fields, you have to specify the key to decode the
message.
If the field “
Node State
” is checked, the Status
byte of the M-Bus node is mapped into a BACnet
Object.
If the field “
Identification Number
” is checked,
the Identification Number of the M-Bus node is
mapped into a BACnet Object;
If the field “
RSSI
” is checked, the RSSI of the
signal is mapped into a BACnet Object.
If
the
field
“
Convert
BCD
in
Integer
Identification Num.
” is checked the Converter
converts the Identification Number that is normally
expressed in BCD in a Integer.
In the field “
Swap Identification Num
.
” it is
possible to select the swap mode of the
Identification Number. If swap isn’t necessary you
have to select “None”; otherwise see the section
“Swap Identification” (page 35) of this document
for select the swap mode.
Figure 4b: “M-Bus Network” window
