Installation and servicing
Information
For more information on the installation and servicing of ADEY’s MagnaClean, call 01242 546717.
Alternatively, visit www.adey.co.uk
Technical specifi cations
MagnaClean
Maximum working pressure: 10 bar
Maximum working temperature: 100°C
Casing
Material: 304L Stainless steel
Shape: Single inlet/outlet, 1¼” BSPT drain plug
Lid Seal: EPDM
Drain
1¼” BSPT drain hole
Gaskets
Material: EPDM
Size: PN16
Inlet/outlet
Size options: 2”, 3’’, 4”, 6”
Flanges: PN16
2’’ 18mm, 4 bolt holes
3’’ 15mm, 8 bolt holes
4’’ 15mm, 8 bolt holes
6’’ 18mm, 8 bolt holes
Magnets
Material: High power, ‘rare earth’ high intensity core
Sleeve: 304L Stainless steel
Lengths: 179mm, 206mm, 229mm, 259mm
Diameter: 25mm
Sight glass
Weld material: DIN1.4404 stainless steel
Collar nut: DIN1.4301/DIN1.4307 stainless steel
Glass: Toughened soda lime to BS3463
Product side seal: EPDM
Outer seal: Non-asbestos fi bre (Klingersil C4400)
MagnaClean
manufactured to EN 13445 : 2009
Service guarantee
MagnaClean will provide years of protection maintaining
the high effi ciency of your heating system and result in
fi nancial benefi t and increased system reliability.
The product is backed by a two year guarantee.
MagnaClean
Product Code
Filter Diameter
(mm)
Inlet size
(mm / ‘‘ )
No. of magnetic
rods
Casing volume
(litres)
CP1-03-01123
160
50 / 2’’
5
3.3
CP1-03-01124
210
80 / 3’’
6
7.08
CP1-03-01125
216
100 / 4’’
7
8.18
CP1-03-01126
324
150 / 6’’
9
26.37
Telephone: 01242 546717 Email: [email protected]
www.adey.co.uk
Produced from recycled material A carbon neutral company
Servicing instructions
Check the MagnaClean sight glass for build-up of
black iron oxide. If a service is required, turn off the
boiler and isolate the electrics. Turn off the isolations
valves on either side.
Unscrew the black retaining knobs on the
MagnaClean lid.
Using the handle, carefully lift out the magnetic cores
and remove from the stainless steel housing.
Take care not to knock or drop the magnetic cores as
this can result in damage.
Connect hose to the 1¼” drain valve and open the
valve or place a bucket underneath and remove the
drain plug.
Slightly open the inlet isolation valve, leaving the
other valve closed, and allow the deposits to drain
through.
Once drained, close the valve and drain point, i.e.
turn off the drain valve or replace the plug.
Replace the magnetic core and tighten the black
retaining knob – Hand tighten only.
Re-open the isolation valves to complete the process.
Use the MagnaClean air-vent to bleed air from the
unit.
Follow the simple steps below when undertaking a service on the MagnaClean in-line fi lter:
DON’T MISS
ADEY’S NEW
industry formula
chemicals now
available in
5L & 10L
1.
2.
3.
4.
5.
6.
7.
8.
For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - [email protected] 0844 556 1818
