4
5
cubes carefully; if no ice blocked, please turn the water box slightly
by hand, 3~5 minutes later, restart the machine. If there is no ice
blocking and also it is no use by turning the box slightly, the ice
maker may need repair. Please ask qualified technician to repair.
7. There are three sizes of the ice cubes available for customers'
selection. The bigger the ice cube is selected, the longer time is
needed to make it. When the ambient temperature is low (lower
than 15
℃
), the small or normal ice cubes are suggested to
choose to avoid the connection between the cubes.
8. Every time when taking out the ice cubes and reinstall the basket,
please push the basket downward to its original position to make
sure the temperature sensor is above the basket so as to ensure the
normal ice making cycle.
1.To ensure the cleanliness of the ice cubes, water in the water storage
tank must be replaced every 24 hours.
2.The water strainer need to be cleaned regularly lest the impurities
in water come into the water pump to effect the normal operation
of machine.
3.If the compressor stops for any reasons such as lacking of water, too
much ice, power off, etc., Don't restart it right away. You should
restart it at least 3 minutes later to protect the compressor.
4.Screw off the drainage screw to drain the remaining water in the tank
when the ice maker will be unused for long time.
5.Please clean the ice maker regularly. When cleaning, disconnect
power and take out the ice cubes, use diluted cleaning agent to clean
the inside and outside surface of the maker. Water spraying for ice
maker is forbidden. Also the chemical diluted agents like acid agent,
MAINTENANCE
OPERATION PROCEDURES
1
.
Open the lid, take out the Ice-Storage-Basket and fill the drinkable
water into the water storage tank directly. Make sure that water level
is not over the bottom of the ice storage basket.
2.Connect power and press the
start
button on the operation board.
Ice maker will begin to work. Different ice sizes could be selected by
pressing the
select
button as per your requirement.
3. The ice making procedures are as follows:
1)Water is pumped into water box from water storage tank.
2)Ice making cycle begins, the evaporator dipped into the water
box starts to make ice;
3)It will take about 7 min ~ 15 min (according to customer's
requirement) for the ice making cycle, after it is finished,
water box will tilt forward and the remaining water will flow
back to the water storage tank.
4)Then water box will tilt backward and the ice pusher will push
the ice cubes into the ice storage basket. After the water box
turns back to the level position, the second ice making cycle begins.
4. The ice maker check the water volume in the Water-Storage-Tank
automatically. If the water volume is too low to make normal ice cubes,
it will stop working. When you add to appropriate water into the
Water-Storage-Tank, the indicator of
water low
will go out and it will
restart to work automatically.
5. When the ice cubes are collected to touch or near the ice sensor, the
ice maker will stop working and the indicator of
ice full
will light;
when you take out the ice cubes , the indicator of
ice full
will go
out and it will restart to work automatically.
6. If the indicators of
ice full
and
water low
glitter at the same time,
please turn off the machine , unplug the power cord and check whether
there are ice cubes blocked in the water box, if so,please take out the
