4) After moving the unit, place the unit for 30 minutes before switching it on.
Running: close the door and connect the power, turn on the lamp switch on the
control panel, the lamp is on. Half an hour later, the temperature inside the case
lower apparently, it indicates the unit on be normally used
5) After connecting the power, the unit should be kept empty for one hour.
6. Setting and adjustment of temperature
1) Adjust the storage temperature through the temperature controller located in
the internal of the case(see the picture), adjust the temperature according to the
ambient temperature and the foodstuff.
2) See the following picture about the knob scale. The temperature adjustable
capacity is from “1”-“5”, adjust the storage temperature by turning the
temperature controller clockwise. The higher of the number shows the lower of
the storage temperature. The knob can turn freely but can't turn clockwise from
“5”to “1”. Factory setting position is on “3”.
Lamp
Switch
Thermostat knob
Control Panel
on
off
3) Check if the scale is on an appropriate position before using,
frequent adjustment is not appropriate when using. Normally in
summer, the ambient temperature is high, anti clockwise turn the knob
to “2”, while in winter, the ambient temperature is low, clockwise turn
the knob to “4”.
4) Position “0” represent stop running.
7. Storage of articles
1) Do not put large amount of articles into the unit at one time, you should
leave some space around the foodstuff to let cold air inside the cabinet counter
to flow. Keep bottled articles away from the walls of interior cabinet so as not
to freeze it until broken.
2) Do not put warm food into the unit directly until they are cooled under
normal temperature, it will facilitate to lower its energy consumption and
prolong service life of the compressor.
8. Maintenance
Disconnect the power supply before maintenance for the machine!
1) Keep the door gasket clean, remove it from the door and wash it.
Dry and seal it as before. Putting some talcum powder on the magnetic
surface would prolong its service life.
2) Bulb replacement
：
remove the lamp shade, take out the bulb,
replace with a new bulb, then mount it again.
3) If there is heavy frost on the evaporator after long usage, take out the
stuff inside the case, disconnect the power, the frost will melt
automatically, clean up the water and connect the power again.
4) Use a soft cloth and dip some water or soap (Non-caustic, neutral
detergent is also available) to clean the unit. Dry the unit after cleaning
to avoid rust.
5) Do not use organic liquid, boiled water, washing powder or acid
stuff to clean the unit. Rinsing the case by water is not allowed, don't
use hard brush, steel brush to clean the case.
6) If the unit will not be used for a long time, disconnect the power,
clean it by following the above steps, wipe off the water inside the case
with a soft cloth.
9
、
Caution
1) The unit is not suitable for storage of blood, pharmaceutical
products and biological products
2) Do not place heavy articles on the top of the unit.
3) In case of trouble, please ask professional person for service, do not
dismantle the unit without prior authority to avoid hazard.
10
、
Normal Phenomena
1) Sometime hear light sound of water flowing in the unit, this is the
sound of refrigerant flowing inside the pipe.
2) In a humidity place, there is dew on the casing or the door, it can dry
by dry cloth.
11
、
Troubleshooting guide
Problems
Possible cause
Ways to solve problems
The units does not
work
Bad connection of
plug
re-connect the plug to
power supply
