EN
sigfox RC4 PULSE V3 - Guide utilisateur / User guide version V1.0.0
24
Page
of 27
FR
3. REGISTERS AND FRAME DESCRIPTION
To know the content of the registers and of each frames (uplink and downlink) of the product, refers to the TECHNICAL REFERENCE MANUAL of
the TEMP product, available on the adeunis website:
https://www.adeunis.com/en/produit/pulse-impulse-interface/
4. CONFIGURATION AND INSTALLATION
To configure the product, it is recommended to use the IoT Configurator (android and Windows application).
- Google Play :
https://play.google.com/store/apps/details?id=com.adeunis.IoTConfiguratorApp
- Windows 10:
https://www.adeunis.com/telechargements/
To configure the product using AT Command or install the product, please refers to the INSTALLATION GUIDE adeunis® available on the web-
site.
5. PREPARATION
5.1. Dismantling the case
The product is supplied disassembled such that the lower electronic part can be accessed. This part is where the meter or meters are connected
to the screw terminals and where the micro USB port for configuration can be accessed.
Once connection of the meters has been finalized and configuration carried out, the case may be closed (be careful that the O-ring seal is not
twisted).
5.2. Installation of the compression seal
Before connecting your meter cables to the product’s screw terminals, you must insert the compression gland nut and the appropriate seal for
your configuration.
3 types of seals are supplied with the SIGFOX PULSE to allow sealing: for a 5 mm diameter cable, for a 3 mm diameter cable, for 2 x 2.2 mm
cables.
Assembly procedure:
Seal for 1 x 5 mm cable
Seal for 1 x 3 mm cable
Seal for 2 x 2.2 mm cables
105
90
27
50
1 - Your meter and its
pulse interface.
2 - Pass the cable
through the compres-
sion gland nut.
3 - Pass the cable
through the compres-
sion gland seal
6 - Connect the
ends of the meter
cable to the screw
terminals.
4 - Pass the cable
through the SIGFOX
PULSE’S case plate.
5 - Verify that the
O-ring seal is correctly
installed on the case
plate (not twisted).