HOW TO INSTALL ON CONCRETE FLOOR
1. Preassemble the above parts in the the same order.
Make sure that the short base plate (D.) is fitted before proceeding.
2. Remove screws, small mounting plate, protective shell and spirit
level.
DISASSEMBLE
4. Fix the bath filler assembly, protective shell and mixer together
with the supplied screws. Ensure that the supply pipes are aligned
and fitted into the mixer before tightening the screws.
5. Cut a 125 x 125mm hole by 70mm deep into the concrete. Make
sure the cut hole provides sufficient space to connect water sources
and a level surface for the mixer to be fixed upon. The hole should
not exceed 150mm or there will be insufficient surface area for
mounting.
6. With the mixer connect and in the correct position, mark the
four floor mounting points of the mixer.
70mm
depth
Small mounting plate
Protective shell
Protective shell
3A. Fix the small mounting plate onto brass fitting from the
bottom with screws supplied.
3B. Screw the fitted assembly onto bottom of the bath filler.
125
125
C.
B.
D.
A.
Small mounting plate
Brass fitting
