ADEO Services MPPH-09CRN1-QB6G1, Owner'S Manual

Page: 136 / 145

Selects the appropriate operating mode.
Each time you press the button, a mode
is selected in a sequence that goes from
COOL, FAN and DRY .The mode indicator
light illuminates under the different mode
setting.
NOTE: On above modes, the unit operates the
auto fan speed automatically. You can
set fan speed only by the remote controller on
COOL and FAN modes.
UP( ) and DOWN( ) button
2
1
MODE select button
Power switch on/off.
ON-OFF button
4
Shows the set temperature while on cool mode.
While on DRY and FAN modes, it shows the room
temperature.
LED Display
OPERATING INSTRUCTIONS
E2- Evaporator temperature sensor error-
Unplug the unit and plug it back in.
If error repeats, call for service.
E4- Display panel communication error-
Unplug the unit and plug it back in.
If error repeats, call for service.
Error codes:
E1-
Room temperature sensor error-
Unplug the unit and plug it back in.
If error repeats, call for service.
Protection codes:
P1-
Bottom tray is full - Connect the
drain hose and drain the collected
water away. If error repeats, call
for service.
Operating Instructions
- Press the "MODE" button until the "COOL"
indicator light comes on. The unit will operate
the auto fan speed automatically.
- Press the ADJUST buttons "
▲
" or " " to
select your desired room temperature. The
temperature can be set within a range of
O O O O O
17 C-30 C/62 F-88 F(or 86 F).
- Press the "FAN" button on the remote cotroller
t o c hoose t he f an s peed.
▲
COOL operation
- Press the "MODE" button until the "DRY"
indicator light comes on.
DRY operation
- Under this mode, you cannot select a fan
speed or adjust the temperature.
- Keep windows and doors closed for the best
dehumidifying effect.
- Do not put the duct to window.
Used to adjust (increasing/decreasing)
O O O
temperature s ettings in 1 C/2 F(or 1 F) inc rements
O O O O O
in a range of 17 C/62 F to 30 C/88 F (or 86 F).
NOTE: The control is capable of displaying
temperature in degrees Fahrenheit or degrees
Celsius. To convert from one to the other, press
and hold the Up and Down buttons at the same
time, for 3 seconds.
3
- Press the "MODE" button until the "FAN "
indicator light comes on. The unit will operate
the auto fan speed automatically. The
temperature cannot be adjusted on fan mode.
- Press the "FAN" b
utton on the remote cotroller
t o c hoose t he f an s peed.
- Do not put the duct to window.
FAN operation
SLEEP operation
To activate SLEEP feature, the set temperature
O O O
will increase by 1 C/2 F(or 1 F) in 30 minutes.
The set temperature will then increase by
O O O
another 1 C/2 F(or 1 F) after an additional 30
minutes. This new temperature will be maintained
for 7 hours before it returns to the originally
selected temperature. This ends the Sleep mode
and the unit will continue to operate as originally
programmed.
NOTE: This feature is unavailabe under FAN or
DRY mode.
This feature can be activated from the
remote control ONLY.
EN