ADEMCO VISTA-128B, Installation And Setup Gude, Page: 59 / 208

Section 9 – Output Devices
9-5
1 2 3 4 5 6 7 8 9
G
R
OU
ND
G
R
O
U
N
D
O
U
T 6 IN 2
G
R
O
U
ND
IN
3
G
R
O
U
N
D
OU
T 5
J8 CONNECTOR
BLACK BLUE BROWN GREEN RED WHITE YELLOW GRAY VIOLET
4142TR CABLE
1 2 3 4 5 6
TB1
-1
TB1
-30
TB1
-2
AC
Earth
Ground AC Sync Data Com
4300 TRANSFORMER/INTERFACE
Figure 9-4: 4300 Wiring Connections
To connect the 4300 transformer, perform the following steps:
Step Action
1 Run a 6-conductor cable between the 4300 interface and the panel.
2 Splice a 4142TR cable to the 6-conductor cable. See Figure 9-4.
Note that the white and yellow wires of the 4142TR must be spliced
together.
3 Connect the 4142TR cable to J8 on the control’s PC board.
4 Set the proper House and Unit Codes for each device following the instructions
provided with each device.
Programming Output Devices
Each output must be programmed to begin one of four types of ACTIONS at a designated
START event, and end that ACTION at a designated STOP event.
The letter(s) in parentheses after each function described below, such as (A) after ACTION,
are those that appear in the various summary displays of programmed data during
programming.
ACTION (A)
The "ACTION" of the device is how the device will respond when it is activated by the
"START" programming. You may want the device to activate momentarily, to pulse on and
off continuously, or to remain activated until some other event occurs to stop it.
There are five different choices of actions:
•
ACTIVATE for 2 SECONDS and then reset.
•
ACTIVATE and REMAIN ACTIVATED until stopped by some other event.
•
PULSE ON and OFF until stopped by some other event.
•
NO RESPONSE when the device is not used.
•
TOGGLE on and off alternately with each activation of event.
START (STT)
The "START" programming determines when and under what conditions the device will be
activated. The following START options are available:
1) EVENT (EV) is the condition (alarm, fault, trouble, restore) that must occur to a zone or
group of zones (zone list) in order to activate the device. These conditions apply only
when a zone list or zone number is used.