!"#$%&'()*+,-./0
K3590-ADCFV1 8/01
DI
D0
_
6160CR-004-V0
+ + +
+
+
RED
BLACK
+ + +
+
Figure 2
SETTING THE KEYPAD ADDRESS
The keypad address must be set according to the control
panel being used (refer to the individual control panel’s
instructions for details). Available addresses are from
00 through 30. The keypad is shipped with a default
address of 31 (non-addressable mode). To change the
address, do the following:
1.
Enter keypad address mode:
Power up the keypad. Within 60 seconds of power-
up, press and hold down the [1] and [3] keys together
for 3 seconds. The current address will be displayed
and the cursor will be under the “tens” d igit (
31
).
Notes:
If a keypad needs to be re-addressed to work with your
control, there is no initial time limit to change the
address. However, once a correct address is entered or
successful communication is made with the control
panel, the following notes apply.
•
If system has been powered up for more than 2
minutes, you must power the keypad down, then
power it up again in order to change the keypad’s
address.
•
The keypad will not enter the address mode if the
system is in the program mode.
•
If 10 seconds have passed with no key entry, the
keypad automatically exits the address mode.
•
The current address may be viewed at any time by
pressing and holding [1] and [3] keys together.
2.
Set the desired address:
Enter the desired address. For example, for address
12, enter 1, then 2. Display shows (12).
3.
Exit the address mode:
Press the “star” key
(
✱
)
to save the displayed address
and exit the address mode.
KEYPAD LABELS
Function key labels:
A set of adhesive-backed labels
with some typical function symbols (e.g., fire, police,
emergency, etc.) is provided. These labels come in four
colors (red, blue, green, and white) and may be placed
on the appropriate function keys (A, B, C, or D) for ease
of identifying the individual key’s function (as
determined by the control panel’s capability and
programming).
SPECIFICATIONS
Physical:
5.250” H x 7.437” W x 1.312” D
Display:
Alphanumeric, 32-character (2 lines x
16 characters), LCD back-lit
LEDs:
Armed (red), Ready (green), *Trouble
(yellow) and *Supervisory (yellow)
* See control panel’s instructions for
specific applications regarding Trouble
and Supervisory LEDs.
Sounder:
High-quality
speaker
Electrical:
Voltage: +12VDC
Current: 45mA standby;
150mA in alarm (sounder,
back light and LED on)
FOR WARRANTY INFORMATION AND LIMITATIONS OF THE ENTIRE SYSTEM, REFER TO THE INSTALLATION
INSTRUCTIONS FOR THE CONTROL PANEL WITH WHICH THIS DEVICE IS USED.
165 Eileen Way, Syosset, New York 11791
Copyright © 2001 PITTWAY CORPORATION
