14
Drainage
During the process of cooling, some water will be extracted from the air into
the unit.
If the reservoir is full, both the compressor and motor will stop and the unit
will make an audible sound (you can press any button to stop the audible
sound). The W.F. indicator will also flash.
Please empty the water by one of the following methods:
1. Turn off the air conditioner and avoid
moving it when full.
2. Position a container (a water tray for
example) underneath the drain hole.
3. Remove the drain knob & rubber plug
from the drain hole and allow the water
to drain out.
4. When the container is almost full,
replace the rubber plug in the drain hole
and empty the water tray.
5. Repeat until the unit is emptied.
6. Replace the rubber plug and tighten
the drain knob firmly.
7. Switch on the unit - the water full or
compressor operating indicator should
not be flashing.
If you wish to operate the unit without
the need to empty the water tank, please:
Remove the drain knob and rubber
plug and retain for future use.
Connect the drain tube supplied to the water outlet as shown and locate
the other end into a drain.
FIG. 15
FIG. 16
