Addonics
T E C H N O L O G I E S
Zebra Snap-In Mobile Rack with
eSATA or eSATA/USB2.0 interface
ZSNESA & ZSNESU
User’s Guide
Version 1.0
FCC Warning Statement
This equipment has been tested and found to comply with the limits for a class B digital
device pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment on and off, the user
is encouraged to try and correct the interference by one or more of the following
suggestions.
Reorient or relocate the receiving antenna
Increase the distance between the equipment and the receiver
Connect the equipment to a different power outlet other than the one where receiver is
connected
Consult a certified television or radio technician
Enclosure Overview
To open the front panel:
1. Using the key provided, place the lock mechanism in the Open position.
2. Pull the lever towards you. This will open the front panel.
3.
Slide the 3.5” SATA drive into the tray.
4. Push the front panel to slide the SATA drive into the tray. You will hear a
clicking sound indicating the front panel is closed.
5. Use the key to place the lock mechanism in the Lock position. This will
secure the drive and also turn on the power.
Power LED: Once the lock mechanism is place on the Lock position, the LED will
turn on. As long as it is on the Lock position, the blue LED is on.
Drive Activity LED: The blue LED will blink if there is activity on the drive.
Lock Mechanism:
Lock
Mechanism
Power LED
Drive Activity
LED
Lever / Handle
Lock
Open
