www.addonics.com
Technical Support (M-F 8:30am - 5:00pm PST)
Phone: 408-453-6212
Email. www. Addonics.com/support/query/
Default settings on the duplicator:
Copy – set to WHOLE MEDIA. This setting copies everything in the source drive to the target
drive sector by sector. This setting ensures a good copy of any drives: boot drive, blank
drive, encrypted drive or drive with any file system.
To speed up the copying, you may change the setting to SYSTEM and FILES. This setting skips
copying sectors with no recognizable data. This is only for drives that have the following file
system: NTFS, FAT/16/32, eXFAT, HFS, EXT3/4 or XFS. This setting is not recommended for
copying boot drive as certain boot sectors may not be copied correctly.
Performance – set to SPEED for best performance. May encounter compatibility issue with
certain old model HDD. Should that occur, try to change the setting to BALANCE or
COMPATIBILITY.
Please review the Compact USB duplicator Controller user manual for all the detail settings.
Making duplicates
Front view
REAR view
Making duplicates
Check to make sure the power switch on the back of the unit is set to the ON position.
Power up the unit by pressing on the ON/OFF button at the front lower right- hand
corner. Once the unit is ready, the LCD should display
HDD Duplicator
1. Copy
The unit is now ready. Simply loads a source drive to the source slot (the first slot on the
top) and the target drives to the seven target slots (the seven slots below the source slot).
After a few seconds, the LCD should display the number of target media detected. Press
the OK button on the LCM control panel to start the copying.
Note: some media may not be detected correctly. In that case, please leave the media
inside the unit and re-start the duplicator.
WARNING
Be sure to set the 110/240V
switch to the correct setting
to your local outlet before
powering on the unit. Wrong
setting may cause damage
to the power supply
