Advanced Setup Options
11-01. Read Error Skip
Allows duplicator to ignore I/O errors while reading source drive. Default setting is OFF.
11-02. Update Firmware
Used to apply firmware updates. Connect a drive formatted as FAT containing one partition
with the firmware file in the root directory.
NOTE: This function scans the entire disk before proceeding. Providing a drive that is as
small as possible is strongly recommended.
11-03. Compare Firmware
Used to confirm correct firmware. Connect a drive formatted as FAT containing one
partition with the firmware file in the root directory.
NOTE: This function scans the entire disk before proceeding. Providing a drive that is as
small as possible is strongly recommended.
11-04. Quick Erase HDD
Scans the ports, then quickly erases all sectors on all connected drives.
11-05. Full Erase HDD
Scans the ports, then completely erases all sectors on all connected drives.
11-06. H/W Diagnostic
Starts comprehensive tests for Ram, LCD, buttons, ports and Flash.
11-07. Load Default
Resets all configuration settings to default.
11-08. Copy HPA
Enables copy functions to duplicate the source drive's Host Protected Area. Normally this
area is defined as not available to a host controller as defined by ATA/SATA specifications.
11-09. Burn In
Runs a function continuously until aborted. Selections are Copy & Compare, Compare,
Async Cpy & Cmp, Async Compare.
Phone: 408-453-6212
Email:
www.addonics.com/support/query/
6
