www.addonics.com
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/
Unpacking and Overview
1
3
4
2
1
1. 2.5” Snap-In Disk Array fits into
standard 5.25” drive bay
2. LEDs for drive activity
3. Key lock to lock drive door
4. 4x Snap-In removable drive bays
allow insertion/removal of 2.5”
SATA drive without requiring any
screws
1.
4x SATA data and power
connections
Front View
Rear View
Installing the Snap-In Disk Array
Step 1.
Slide the 2.5" Snap-In Disk Array into a standard 5.25” drive bays
on your system or storage chassis.
Step 2.
Secure the Snap-In Disk Array to the drive bay on both sides
with the screws that come with the unit. Note: using other long screws
may interfere with the hard drive installation.
Step 3.
Using the included Y power cable, connect the two female SATA
power connectors and 4-pin LED connectors to two ports on the rear of
the unit. Repeat the process for the other two ports.
Step 4.
Connect the 4 SATA data connectors to the SATA ports on the
motherboard or SATA controller inside your system.
Step 5.
Power on your system. Check to make sure the main power LED
is lit and that the two cooling fans are spinning.
