Installation:
1.
Locate the SATA connector of your SATA drive.
2.
Connect the converter board to the SATA connector of the hard drive.
3.
Using the provided Y-power cable, connect the 4-pin Floppy connector to
the converter. This will provide power to the converter and to the hard
drive.
4.
Connect the IDE ribbon cable to the 40-pin connector on the converter.
The red edge of the ribbon cable needs to line up to pin 1 marker of the
40-pin connector. The other end of the ribbon cable will be connected to
your motherboard’s IDE channel.
15-Pin SATA Power
& 7-pin Data Connector
