Additel 273E Series, Manual

Page: 49 / 56

39
4. Finish the task
After the task is finished, click the save button to go to the Saving interface, fulfill the information required and
save the task data of the result.
Table 14 Save task data setting
Subject Valid value Description
Name Numbers, letters, symbols Task name
Operator Numbers, letters, symbols Information for operator
Date and time Valid date and time Date and time of the task performing
Note Numbers, letters, symbols Additional information
6.2 Pressure transmitter (voltage, current and HART)
1. Connect to DUT
•
Connect the internal pressure module. If using an external pressure module, connect them to LEMO port A
or B.
•
Connect the DUT output with the calibrator according to the signal type, current (Figure 7), voltage (Figure
6), or HART (Figures 10 and 11).
2. Create the task
Create the corresponding DUT tasks as described above, and enter the necessary information.
Table 15 Pressure transmitter task setting
Subject Valid value Description
Pressure type Gauge / absolute / differential Pressure type of DUT
Input range Numbers Input range of DUT