2
www.addi-data.com
Connecting the Ethernet system
- Please read the safety precautions (yellow leaflet) first!
- Afterwards, connect your Ethernet system as follows:
A) Connect the Ethernet system to your PC or network using an Ethernet cable
(e.g. CMX-60).
B) Connect the desired functions.
C) Optional: Connect the cable for trigger/synchro signals (e.g. CMX-40) to the Ethernet
system.
NOTICE!
Please ensure that the default IP address of the Ethernet system
(192.168.99.99) is not assigned to another system on your network yet.
Starting the Ethernet system
D) Connect the Ethernet system to the power source using a power supply cable
(e.g. CMX-20).
E) Check the status of the Ethernet system by means of the LED display:
Power On:
- lights green
= Power supply is OK
Port 0 ACT/Link: - flashes yellow
= Ethernet cable is connected to Port 0
Port 1 ACT/Link: - flashes yellow
= Ethernet cable is connected to Port 1
Status:
- lights green
= Ethernet system is ready for operation
- lights yellow
= Ethernet system is booting
- lights/flashes red
= Error while booting
As soon as the “Status” LED lights green, you can install the software (see page 5).
CMX-20:
Power supply cable
Intelligent
Pressure
System
CH0-CH1
CH2-CH3
CH4-CH5
CH6-CH7
CH8-CH9
CH10-CH11
CH12-CH13
CH14-CH15
(E) LED display
(B) Sensor inputs (0 to 15)
(D)
Power
supply
(A)
Ethernet
ports
(C)
Trigger/
Synchro