Software
PA 200
18
DMA (ISA boards only):
Indicates the selected DMA channel or "Not available" if the board uses no DMA
or if the board is no ISA board.
More information:
Additional information like the identifier string or the installed COM interfaces. It
also displays whether the board is programmed with ADDIDRIVER or if a
PCI
DMA
memory is allocated to the board.
Text boxes:
Base address name:
Description of the used base addresses for the board. Select a name through the
pull-down menu. The corresponding address range is displayed in the field below
(Base address).
Interrupt name:
Description of the used IRQ lines for the board. Select a name through the pull-
down menu. The corresponding interrupt line is displayed in the field below
(Interrupt).
DMA name (for ISA boards only):
When the board supports 2 DMA channels, you can select which DMA channel is
to be changed.
DMA channel (for ISA boards only):
Selection of the used DMA channel.
Buttons:
Edit:
Selection of the highlighted board with the different parameters set in the text
boxes.
Set:
Sets the parametered board configuration. The configuration should be set before
you save it.
Cancel:
Reactivates the former parameters of the saved configuration.
Default:
Sets the standard parameters of the board.
More information (not available for the boards with ADDIPACK)
You can change the board specific parameters like the identifier string, the COM
number, the operating mode of a communication board, etc...
If your board does not support these information, you cannot activate this button.
