ADDER X-KVM/P, Installation & Use Manual, Page: 21 / 57

AdderLink X-Series Installation and Use Page 19
LOCAL unit — Switch 2
This switch sets “transparent mode” operation. This mode is useful if the X-KVM is
to be used to link KVM switches that are not made by Adder Technology. Cascaded
KVM switches often use undocumented data to signal special conditions. In
transparent mode the X-KVM will enable this undocumented data to be transferred
between devices.
LOCAL unit — Switch 3
If this switch is set to the ON position then the remote unit will go directly into
compensation / configuration mode at power on. This enables a password locked
remote unit to be reset. See section 4.6 for further details.
LOCAL unit — Switch 4
This switch may be used to reset the local unit without disconnecting the power. In
the OFF position the X-KVM will operate normally. In the ON position X-KVM will
suspend all operation and reset itself to the power off condition. Cycling the switch
from the OFF position to the ON position and back to the OFF position again will
perform a reset without having to disconnect the computer connection cable.