WARNINGS
•
Motor is water resistant but not submersible. Do not use product in sinks or tanks where there is a risk of
falling over or submersing
•
Always observe water level labels on product
•
Motors may get hot with extended use.
•
Plug only into a 3-hole grounded electrical outlet
•
Ensure that the designated power supply is adequate for continual usage and the voltage is correct
•
Keep electrical cord clear of brushes and water
•
Unplug cord from outlet when not in use and before cleaning
•
Do not operate product out of water
•
Ensure brushes are securely in place before turning product on
•
Do not use this unit for anything other than intended use
•
Do not use if unit has a damaged cord or plug
•
In the event the appliance malfunctions, unplug immediately
•
Keep children and animals away from unit
•
Any incorrect installation, alterations, adjustments and/or improper maintenance can lead to property
loss and injury. All repairs should be done by authorized professionals only
•
Always keep product upright
TO USE
1.
Place product in sink and fill with warm water to the top of the lowest brushes or the
water line label.
2.
Plug product into a grounded outlet and turn machine on.
Only use “low suds” detergent in water. Granular (powder) detergents are not
recommended.
For best results, wash one glass at a time. Always start the glass washer before
placing a glass over the brush. Center brush is designed to clean the inside of the
glass while the four outer brushes wash the outside. For optimal glass cleaning, rinse
in fresh water in another sink and sanitize glass in a third sink. Set glasses aside to
drain.
CLEANING AND MAINTENANCE
•
Drain sink and wipe off machine every night
•
Allow for glass washer to dry overnight
•
Once a month, lift off rubber band that protects the gear housing. Immerse product in enough
water to cover brushes and add a half cup of vinegar or bleach. Run product for 10 minutes,
rinse thoroughly and replace band.
