6240B DC Voltage Current Source/Monitor Operation Manual
6.7.3 Remote Command List
6-27
Source Time parameter
SP
Th,Td,Tp[,T
w]
Th: Hold time
3 ms
Td: Measurement delay time Unit: ms
4 ms
Tp: Period Tw can be omitted.
50 ms
Tw: Pulse width
25 ms
SP?
Response: SP<Th>,<Td>,<Tp>,<Tw>
Th,Td,Tp,Tw:<d.dddd>
*1
SD Tds
Tds: Source delay time (unit: ms)
0.03 ms
SD?
Response: SDd.dddd
*1
Response
FL0
SLOW
FL1
FAST
FL?
Response: FL0 or FL1
Sweep
Linear sweep
SN
[
st,
sp,
step]
st: Start value
0.01 mV/
0.001 µA
sp: Stop value
1 mV/
0.1 µA
step: Step value (The polarity is ignored.)
0.01 mV/
0.001 µA
If all the settings are omitted, set the sweep type only.
However, it is not allowed to omit each value sepa-
rately.
SN?
Response: SN ± <st>, ± <sp>, <step>
*1
st,sp,step: <d.ddddE
d>
Fixed level sweep SF [
lvl,
cnt]
lvl: Level source value
0 V/0 A
cnt: Sampling count (1 to 8000)
1
If all the settings are omitted, set the sweep type only.
However, it is not allowed to omit each value sepa-
rately.
SF?
Response: SF
<lvl>,<cnt>
*1
lvl: <d.ddddE
d>
cnt: <dddd>
Random sweep
SC [st,sp]
st: Start address (0 to 7999)
0
*3
sp: Stop address (0 to 7999)
0
If all the settings are omitted, set the sweep type only.
However, it is not allowed to omit each value sepa-
rately.
SC?
Response: SCst,sp
st,sp:<dddd>
*1:
The decimal point position in response varies depending on the setting value.
For the source value, limit value, and time parameter setting ranges, refer to the specifications.
*3:
The values can be changed only between the start and stop addresses that were set in the Standby status.
Item
Command
Description
Default
Operation
Power ON
Factory
shipment
DC/pulse
OPR/SUS
Sweep
OPR/SUS
{
