6240B DC Voltage Current Source/Monitor Operation Manual
4.2.6 MENU Key (Parameter Setting)
4-13
PARAMETER
Loads or saves the setting parameters.
Parm Load
Loads the setting parameters from the non-volatile memory.
Not displayed on the menu screen in Operate status.
Load0:
Loads the data from area 0 of the non-volatile memory
as setting parameters.
Load1:
Loads the data from area 1 of the non-volatile memory
as setting parameters.
Load2:
Loads the data from area 2 of the non-volatile memory
as setting parameters.
Load3:
Loads the data from area 3 of the non-volatile memory
as setting parameters.
Ld Dflt: Loads the factory default parameters as setting
parameters.
Parm Save
Saves the setting parameters to the non-volatile memory.
Save0:
Saves the current setting parameters to area 0 of the
non-volatile memory.
Save1:
Saves the current setting parameters to area 1 of the
non-volatile memory.
Save2:
Saves the current setting parameters to area 2 of the
non-volatile memory.
Save3:
Saves the current setting parameters to area 3 of the
non-volatile memory.
Sv Dflt: Saves the factory default parameters to all the areas 0 to
3.
PON. Load
Selects the parameter loading condition at power ON.
P.OFF:
Starts up using the parameters when the instrument was
last turned off.
Load0:
Starts up using the parameters saved in area 0 of the
non-volatile memory.
I/F
Selects or sets the interface.
I/F BUS
Selects the interface.
GPIB:
Selects the GPIB interface.
USB:
Selects the USB interface.
GPIB Adr
Sets the GPIB address from 0 to 30.
Displayed only when the GPIB interface is selected.
USB Id
Sets the USB ID from 1 to 127.
Displayed only when the USB interface is selected.
