ADCP-80-531 • Issue 4 • July 2004
Page 12
© 2006, ADC Telecommunications, Inc.
1.12 Circuit Breaker Designation Card and Holder
A circuit breaker designation card as shown in
and a card holder are provided with the
circuit breaker panel. The card holder is intended to be attached to the underside of the panel,
one of the panel mounting brackets, to a part of the rack in which the panel is installed, or at a
location close to the panel, as desired. The card should be filled out with circuit information for
each of the circuit breakers installed in the panel and inserted in the card holder. The card holder
has a pressure sensitive adhesive backing for attachment.
Figure 4. Circuit Breaker Designation Card
1.13 Voltage Designation Label
A voltage designation label as shown in
is provided with the circuit breaker panel. The
label is intended to be filled out with the actual voltage present on the buses and placed on the
panel. The voltage designation label has a pressure sensitive adhesive backing for attachment.
Figure 5. Voltage Designation Label
1.14 Material and Finish
The circuit breaker panel chassis and brackets are made of 16-gauge cold rolled steel. The panel
and brackets are finished with powder paint.
16753-A
1.60 IN.
(4.06 CM)
2.36 IN.
(5.99 CM)
10 POSITION A AND B CARD
0.38 IN.
(0.96 CM)
1.00 IN.
(2.54 CM)
14228-A