ADC FRE-765, Manual

Page: 17 / 30

SCP-FRE765-041-03H Functional Description
FRE-765 List 4A January 6, 2003 7
I
NSTALLATION AND
T
EST
Mounting
The FRE-765 mounts on a pole or a wall. Follow local practices to ensure a secure mounting. Mount the FRE-765
for easy access to the cable entry points on the bottom of the enclosure. Provide ample room to open the door
completely.
For pole mounting the FRE-765, use the Pole Mounting kit, part number FMK 2397 List 1. Follow the instructions
that are included to install the pole mounting bracket. Then mount the FRE-765 to the bracket. Do not install any
cabling until the FRE-765 is securely mounted.
When required, install the grommet into the base of the FRE-765 (see Figure 2, “Installing the Grommet,” on page
7 ) prior to performing any wiring. Table 7, “Grommet Hole Diameters,” on page 7 shows the wire gauges that you
can install through the holes in the grommet):
1 Select only one concentric knockout hole on the FRE-765.
2 Remove the largest knockout so that the entire hole is open.
3 Install the grommet from the outside of the FRE-765. (Hint - Hold it at an angle to the hole and roll it into
position.)
4 Ensure that the lip of the grommet rests on the bottom of the FRE-765 around the knockout hole.
5 Use an appropriate tool to open the required hole(s) in the bottom of the grommet.
Figure 2. Installing the Grommet
Table 7. Grommet Hole Diameters
For this grommet hole size Use this cable
.410 to .765 in. diameter (two)
*
(*) Recommend using one hole for both the HDSL and the bypass pairs (i.e., 6-pair cable) and using the second hole for POTS (subscriber)
lines.
• 24 or 26 AWG, 25- or 50-pair Primary Interexchange Carrier (PIC) (filled or non-filled)
• 22 AWG, 25-pair PIC (filled or non-filled)
• 22, 24, or 26 AWG, 6- or 11-pair PIC (filled or non-filled)
.240 to .275 in. diameter (one)
ground wire †
(†) Dependent upon gauge of wire used.
.155 to .240 in. diameter (one) ground wire
Grommet
FRE-765 enclosure
(bottom view)
Grommet lip