ADC and V35, User Manual

Page: 87 / 103

ADCP-50-304 • Issue 19 • June 1999 • Section 7: Operation
Page 7-12
© 1999, ADC Telecommunications, Inc.
6.19 TLKxx Execution
CRT actions and displays involved in operating in the TLKxx format are shown in Figure 7-1
and defined in Table 7-3 .
Enter TLKxx with xx equal to the two-digit chassis address (00 to 15) and press RETURN.
Completion of chassis selection always results in a status display of the selected chassis
followed by the Select Operation Menu. If the chassis had previously been selected by the SC
command and a GS command was executed, the status display is preceded by a message
indicating successful or unsuccessful execution of the command. SC and GS commands are
described later in this section.
Figure 7-1. Chassis Selection and Configuration via TLKxx Command
1638-A
OR OR
GS APPLICATION XXXXXXXXXXX
FAILED
GS APPLICATION XXXXXXXXXXX
ON-LINE
ENTER
TLKxx
GS EXECUTED
IN SC COMMAND
GS NOT EXECUTED
IN SC COMMAND
STATUS
DISPLAY
SELECT
OPERATION
1. SWITCH
2. SETUP
3. STATUS