4. a. Thread probe connector through probe connector housing.
b. Align probe connector as shown and push gently until it clicks into place.
c. Pull excess probe cord through slot in probe connector housing and slide into place as shown.
5. Probe connector housing should be fully
seated against rear cover with no visible gaps.
6. Slide part b onto part a as shown (this connects the
temperature probe connector to the temperature unit connector),
and insert the temperature probe into the well. Place the
probe cover box (part c) into the holder.
7. Turn the device ON using the Power button on the right side of the
BP module. At the end of the start-up sequence, the temperature
module display will be blank except for the appropriate temperature
unit icon (°F or °C). A short beep indicates that the
ADC AdView
™
Modular Diagnostic Station
is ready.
Note:
If the temperature module does not appear to be working properly,
cycle the power several times using the Power button on the right side of the BP module.
This will “synchronize” all the modules. The modules are synchronized when, after you turn the
power on, all segments on all modules display light simultaneously for 3 to 5 seconds, followed
by a short beep, and all displays go to their “ready” state
(BP: battery icon and middle
segments of the systolic value are lit; Temperature: appropriate temperature units icon is lit;
Pulse Oximetry: the “%SpO2” icon is lit).
Refer to the
ADC AdView
™
Modular Diagnostic Station
user’s manual for operation,
maintenance and safety instructions.
c
b
a
ADC
55 Commerce Drive
Hauppauge, NY 11788
Suntech Medical, Ltd.
Oakfield Industrial Estate
Eynsham, Oxfordshire
OX29 4TS UK
Inspected in the U.S.A.
Made in China
tel: 631-273-9600
toll free: 1-800-232-2670
fax: 631-273-9659
www.adctoday.com/adview
To Register Your Product, visit us at
www.adctoday.com
and follow the links
For questions, comments, or suggestions,
call in the U.S.A. Toll Free:
1-800-ADC-2670
IB p/n 93-9000TO-00 rev 1 Printed in the USA
4a
4b
4c
