4.2 Replacing LED Mounting Assembly
Disconnect the power to the light assembly and remove the entire assembly from the location site. Unscrew and remove the
glassware assembly from the top of the obstruction light assembly. See.
Figure 3
Note
The individual LEDs are not replaceable. The entire LED mounting assembly must be replaced.
Lift the LED mounting assembly out of the fixture housing and locate and pull off the two-pin quick-disconnects on the PCB
assembly. Connect the new LED assembly leads to the PCB. See
Figure 4
Note
Insure that the two leads do not become pinched when placing the LED assembly back into the housing and the
glassware assembly is screwed back onto the housing.
Reinstall the glassware assembly on to the top of the housing. Reinstall the repaired fixture back at the site location.
Figure 4: LED Mounting Assembly (LED Lead Quick-disconnect)
LED Assembly
Quick
Disconnect
4.3 Replacing LED PCB Assembly
Disconnect the power to the light assembly and remove the entire assembly from the location site. Unscrew and remove the
glassware assembly from the top of the obstruction light assembly. See
Figure 7.
L-810(L) SBOL - Steady Burning LED Obstruction Light
Maintenance and Repair
12
Copyright
©
ADB Safegate, All Rights Reserved
Summary of Contents for L-810(L) SBOL
Page 1: ...L 810 L SBOL Steady Burning LED Obstruction Light User Manual 96A0328 Rev J 2018 06 26 ...
Page 2: ......
Page 28: ......
