Adaptive
Technologies
Group
1635
E.
Burnett
Street
|
Signal
Hill,
CA
90755
USA
Ph:
562.424.1100
|
Fax:
562.424.3520
ALWAYS
INSTALL
SAFETY
CABLES
WARNING:
Mounting and/or suspension loudspeakers requires experienced
professionals. Improperly installed loudspeakers can result in property damage,
personal injury and/or liability to the installing contractor
Installation Guide
SAS-200-24-
32” LINE ARRAY WALL MOUNT
Note: Do not directly install to drywall without proper backing plates or
plywood.
Step 3: Install Cross-Arm
Install cross-arm to the selected hole of the line array wall mount using the
provided hardware. Make sure that the neo-washer is in between the Cross
arm and the wall arm tube. Position the desire speaker direction then
permanently tighten the bolts (Figure 2).
Step 4: Attach Speaker (Without Using of Cross Arm)
To attach speaker without using of cross-arm, Attach the ½-13x3.25” eyebolt
with the line array wall mount using the provided hardware, after that attach
the linery-grid frame to the eyebolt using the shackle with pin. In last attach
the linery- speaker to the linery-grid frame (Figure 3 & Figure 4).
Step 5: Recommendation- Install Safety Cable
Install safety cable to the structure and then attach the other end of the
safety cables to the speakers to bypass the mounting system. Attachment
to structure must be able to support 5 times the load of the speaker and wall
arm mount.
Figure 1
Figure 2
SAS-500-WM
Figure 3
Figure 4