Adaptive Recognition AFS 510, Install Manual

Page: 11 / 30

Page 11/30
Passport Reader Install guide
Adaptive Recognition America
Adaptive Recognition Hungary
Adaptive Recognition Nordic
Adaptive Recognition Singapore
SENDINFO@ADAPTIVERECOGNITION.COM
WWW.ADAPTIVERECOGNITION.COM
Hardware Installation
Please follow the steps below to connect your PR device to the PC.
1. Connect the PR device to one of the USB 2.0 or 3.0 ports of your PC with the supplied USB cable.
2. Connect the power supply
*
to the device.
*
Only applicable to the devices shipped with a power supply.
3. If the device is equipped with a power button, switch it on. Models that do not have power buttons
will power on automatically once power is supplied.
If the device is used with a laptop, please make sure that the output voltage of the USB ports is not
less than 5V. For this reason, it is highly recommended that you use the laptop on AC power (with the
power cord connected).
It is strongly recommended to use the USB ports found on the motherboard of your
computer. When connecting the USB cable to a front panel USB port, make sure that the
cable connecting the front panel and the motherboard is shielded.