Quick Star
t
March 16, 2007
© 2007 Adaptive Micro Systems LLC. All rights reserved
PN 1199611201B
Before you start
You will need the following items:
•
Ethernet cable or Ethernet crossover cable (for setting up a direct
connection)—included with the sign
•
computer or laptop
•
ooh!Media CD—included with the sign
•
the sign’s network settings (at least the IP address, Subnet Mask,
and Default Gateway)
What is a direct connection?
A direct connection is primarily used to test the sign
communications. It requires a direct connection with a computer
or laptop via a crossover cable and is not ideal for a permanent
communication or networking solution.
Overview
These instructions apply to setting up an AlphaEclipse Excite™
23mm pitch sign on an Ethernet network or testing
communication via a direct connection.
Step
Description
Purpose
1
Connect the sign to the
network
In order to communicate with the
sign, it must be on the network or
connected to the host computer
2
Install ooh!Media
ooh!Media is the software that you
will use to send messages to the
sign. The computer it is installed on
is referred to as the “host” computer.
3
Send a test message
You will verify communication
between the host computer and the
sign by sending a test message to
the sign.
1) Connect the sign to the network
WARNING!
Hazardous voltage. Contact with high voltage may cause death or
serious injury. Always disconnect power to unit prior to servicing.
A.
Disconnect all power from the sign at the power source.
B.
At the sign, open the case door labeled
Controller
(bottom left-
most case)
•
Using a 5/32-inch hex tool, turn screw counter-clockwise.
•
Slowly pull the door toward you to open.
C.
For a network connection:
Route the Ethernet cable from your network through the hole in
the back of the controller case and plug into the Ethernet
connection.
D.
For a direct connection:
•
If this is the permanent connection, route the crossover cable
through the back of the sign.
•
Connect one end of the Ethernet crossover cable to the connection
labeled Ethernet in the sign’s controller case.
•
Connect the other end to your computer’s Ethernet port.
E.
Close the case door.
F.
Apply power to the sign.
5/32-inch hex tool
Route the Ethernet cable from your network through this hole
Plug the Ethernet cable in here
Plug Ethernet crossover cable in here
Route the crossover cable from
your computer through this hole
Connecting
the Excite Sign to an Ethernet
Network
