2-9
Installation
4
Install the host adapter device driver, as described in the
following section.
Installing the Device Driver (Version 2.0 or Later)
for Solaris/SPARC 2.5.1 or 2.6
You can install AHA-2940UW/OF and AHA-2944UW/OF device
drivers either from a floppy disk or from the Adaptec Web Site.
Follow the procedures below to install the device drivers.
Installation from a Floppy Disk
1
Log on to the Solaris operating system as
root
.
1
Insert the 7800 Family Open Firmware Manager Set, v2.0 device
driver installation diskette into the floppy drive.
2
At the superuser prompt (
#
), type the following command and
press Enter:
/etc/init.d/volmgt stop
3
Then type the following and press Enter:
pkgadd -d /dev/fd0
The following software package is displayed:
4
Select the package by typing
1
or
all
and pressing Enter to
install the device driver.
5
Press Y to answer yes to each question that follows.
6
When the following message is displayed, type
q
to quit the
installation:
Installation of <ADPadp> was successful.
7
Reboot the system to enable the new device driver to take
effect.
1 ADPadp
Adaptec 294X(U)W/394X(U)W/4944(U)W SCSI
Host Adapter Driver
(UltraSparc) release v2.00
