Chapter 7: Installing the Driver and an Operating System
●
52
8
Continue with the instructions for your operating system:
●
For Windows, see below.
●
For Red Hat Linux, see
.
●
For SuSE Linux, see
●
For NetWare, see
Installing with Windows
Note:
You will need your Windows installation CD to complete this
task.
To install the ICP RAID controller driver while installing Windows:
1
Insert your Windows CD, then restart the computer.
2
Follow the on-screen instructions to begin the Windows installation.
3
When prompted to install a third-party driver, press
F6
.
Note:
When F6 is active, a prompt appears at the bottom of the
screen for only 5 seconds. If you miss your chance to press F6, restart
your computer.
4
Insert the driver disk, then wait until you are prompted to install a
driver.
5
Press
S
to specify that the driver is on a floppy disk, then press
Enter
.
The computer reads the disk.
6
When the ICP driver is found, press
Enter
.
7
Follow the on-screen instructions to complete the installation.
8
Continue with
Managing Your Storage Space on page 60
.
