Adaptec 2060100, Manual

Page: 123 / 206

11-2
Adaptec Ultra320 SCSI Cards User’s Guide
If you are performing a first time UnixWare/Open Unix
installation, see
Installing the Driver When Installing UnixWare/Open
Unix on page 11-2 . If UnixWare/Open Unix is already installed in
your system, see Installing the Driver When UnixWare/Open Unix is
Already Installed on page 11-4 . If you are performing a first time
OpenServer installation, see Installing the Driver When Installing
OpenServer on page 11-8 . If OpenServer is already installed in your
system, see Installing the Driver When OpenServer is Already Installed
on page 11-8 .
Note: UnixWare/Open Unix, and OpenServer installation
requires that the host adapter driver be installed from a disk.
See
Appendix D, Creating Driver Floppy Disks for UnixWare/
Open Unix, and OpenServer driver disk creation.
Installing the Driver When Installing UnixWare/
Open Unix
To install the
adpu320
driver at the same time you install
UnixWare/Open Unix:
1 Insert the Install CD of the UnixWare/Open Unix package into
the boot CD-ROM drive. Start your computer.
Wait for the first UnixWare/Open Unix installation screen and
prompt to appear, then follow the on-screen instructions.
2 When prompted to either Install Host Bus Adapter Drivers or
Continue Installation , select Install Host Bus Adapter Driver
and press Enter.
3 Insert the Ultra320 driver disk for UnixWare/Open Unix into
the primary floppy disk drive and press Enter (you cannot load
drivers from a secondary floppy disk drive). (See
Appendix D,
Creating Driver Floppy Disks for information on creating driver
floppy disks.)
As the driver loads, a message identifying the installed host
adapter briefly appears on screen. The installation process
determines which device drivers on the disks are needed.
U320 UG.book Page 2 Tuesday, September 23, 2003 1:47 PM