The installer may also use the Antenna Pointing Tool on this tab to point the Remote Site's
directional antenna towards the Base Station.
Note: The Channel Set must be set before the radio can become operational; this is described in
the Channels Tab section
Figure 1.3-1: Startup Config Tab
1.3.1
Network Configuration Panel
1.
Set the
Network ID and Radio Function fields:
•
Enter the
Network ID in decimal or hexadecimal (beginning with “0x”). For example:
25238 (decimal) or 0x6296 (hexadecimal). These two example values are equivalent
(refer to the same network). The
Network ID is comprised of two values that must be
accurately entered: the Multi Tx/Rx field and Single Tx/Rx field.
•
Click the
Network ID checkbox (if it is not already checked).
•
Select a radio type by clicking the appropriate option (
Factory Default, Hub (Base
Station) or Remote) in the Radio Function area.
•
Click the
Radio Function checkbox (if it is not already checked).
•
Click the
Send Config to Radio button.
Summary of Contents for XG1
