Customer telephone helpline: 08448 809301
Helpline email address: [email protected]
CO9071 V2_020611
- 3 -
ELECTRICAL SPECIFICATIONS
Important Electrical Safety
The heater must not be located immediately below a socket outlet. The socket must always be
accessible in order to disconnect the heater from the electrical supply for maintenance and
cleaning.
IF THE HEATER IS WALL
MOUNTED IT MUST BE AT LEAST
300MM OFF THE FLOOR TO
PROVIDE ENOUGH AIR INTAKE.
IF THE HEATER IS WALL
MOUNTED IT MUST BE AT LEAST
450MM OFF THE CEILING TO
AVOID OVERHEAT AT THE
CEILING.
WARNING: THE HEATER MUST
NOT BE USED IF THE GLASS
PANEL IS DAMAGED
Important!
The heater is for household and indoor use only.
When the appliance is not in use and before cleaning, unplug the appliance from the outlet.
The heater must not be located immediately below a socket outlet.
The plug must be accessible after installation to allow for isolation in an emergency.
Do not spray liquids directly onto any surface of the unit.
This heater must be earthed.
The mains supply cord must be safely routed from the heater
to an electrical socket.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or
a similarly qualified person in order to avoid a hazard.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have had
supervision or instruction concerning use of the appliance by a person responsible for their
safety.
To protect against the risk of an electric shock, do not immerse the unit, cord or plug in water
or other liquid.
Do not use this heater in the immediate surroundings of a bath, a shower or a swimming
pool.
Children should be supervised to ensure that they do not play with the appliance.
WARNING: This heater is not equipped with a device to control the room temperature. Do
not use this heater in small rooms when they are occupied by persons not capable of the
leaving the room on their own, unless constant supervision is provided.
WARNING: In order to avoid overheating, do not cover the heater.
Note:
Any new wiring must be installed in compliance with local and national codes of practice
and other applicable regulations in order to reduce the risk of fire, electric shock, or other injuries.
WARNING: Do Not Cover
