Wiring 128x32 SPI OLED display
128x32 SPI OLED
The 128x32 SPI OLED is very easy to get up and running because it has built in level shifting.
First up, take a piece of 0.1" header 8 pins long.
Plug the header long end down into a breadboard and place the OLED on top. Solder the short
pins into the OLED PCB.
Finally, connect the pins to your Arduino - GND goes to ground, Vin goes to 5V, DATA to
digital 9, CLK to digital 10, D/C to digital 11, RST to digital 13 and finally CS to digital 12.
(Note: If using the display with other SPI devices, D/C, CLK and DAT may be shared, but CS
© Adafruit
Industries
http://learn.adafruit.com/monochrome-oled-breakouts
Page 14 of 22
