ADA INSTRUMENTS TemPro 1600, Operating Manual

Page: 13 / 60

TemPro
-
1200/1600/2200
MEASUREMENT FOUNDATION
1
Recalling data
To recall stored data after the unit shuts off, press the “MODE” button until LOG appears in the lower left corner.
A LOG location number will be shown below LOG, and the stored temperature for that location will be displayed.
To mo�e to another LOG location, press the “Down” �2� and “Up” �3� keys.
Log clear function
The “Log clear” function allows you to clear quickly all logged data points. This function can be only used when
the unit is in LOG mode. It can be used when the user has any number of LOG stored locations.
You should only use the LOG clear function if you want to clear all the Log location data stored in unit’s memory.
While in LOG mode, press the trigger �5� and then press the “Down” �2� arrow button until you reach “0” LOG
location.
Note: This can be done when the trigger is pulled. LOG location “0” cannot be accessed by pressing “Up” �3�
arrow button.
When “0” LOG location is shown on the dispaly, press the Laser/Backlight �1� button. You will hear sound and “0”
will automatically change to “1”. All data locations ha�e been cleared.
7. Operation
Preparation before operation
Read the operating manual before use the instrument.
Take the instrument out of case.
Open battery co�er and put 9V battery.
Thermometer On/Off
Pull and hold the trigger �5� to turn the meter on and begin testing. The display will light if the battery is good.
Replace the battery if the display does not light. The meter will automatically power down after approximately 7
secondsafter the trigger is released.