ADA INSTRUMENTS DigiTeo-10, Operating Manual, Page: 17 / 58

MEASUREMENT FOUNDATION
17
Digi Teo-2/5/10/20
2. Correction function (DigiTeo-2; 5)
DigiTeo-2 has a vertical axis incline compen-
sate. It can self-motion compensate the incline
angle. When the incline sensor is switch on,
the instrument can display the vertical axis
incline angle. We can adjust the instrument
level exactly by hand through the data. When
it incline over the compensate arrange, the
instrument display “TILT”. We must level the
instrument.
Note:
●
In gale day or the quiver surrounding, the angle display is not stabili-
zation. You should close the compensate before you measure it.
● Set or close the compensate function, please read the “setup”.
3. Illumination and timing close
DigiTeo have a display and a illumination setting on the reticle. When
you press [SFT] over 2 seconds, the display and the illumination setting
will be open or closed.
If you don’t operate the instrument for 20 minutes or 30 minutes, the
power will be closed. About this function, you can reference the setup.
The other function
1. Measuring distance stadia hairs
So scale station pole is needed, for example horizon-
tal measuring staff and apparent distance staff. By
viewing through the telescope, the length between
upper and under stadia hairs which multiplies 100 is
the distance from instrument center to station pole.
(The length refers to the reading from station pole
between two stadia hairs).
a. First fix the station pole at the measuring point.
b. Level instrument. By viewing through the telescope,
make sure the reading “ ” between two stadia lines.
c. The distance from instrument plumb bob center to
station staff “L” is 100 times of “l”: L = 100
X
l
stadia hairs