CHECKS BEFORE STARTING UP
•
Check that the safety valves (DHW and primary) are correctly installed and that the outlets are
connected to the sewer.
• Check that the DHW tank and the primary circuit are filled with water.
• Check that the air has been correctly bled from both circuits.
• Check that the tank’s upper air bleed valve is tight.
• Check that the water side and heat source side pipes are correctly connected and not leaking.
• Check that the sensor of the thermostat is correctly positioned in the dry well (see figures
below).
STARTING UP
If the tank is used as electric DHW tank only:
1.
Put the electric plug into the mains socket
2.
Adjust the required temperature using the control thermostat integrated in the electrical
resistance.
If the tank is used within a heating installation:
To put the installation into service, refer to the heating boiler manual.
1.
Adjust the required temperature using the control thermostat of the tank.
EN
FR
NL
ES
IT
DE
PL
RU
en
22
Smart Line SLE - SLE Plus
: 661Y2100 • A
STARTING UP
