SETUP
5-in-1 Sensor Setup
1
Set the A-B-C Switch
Locate the A-B-C switch inside the
The 5-in-1 sensor requires lithium
battery compartment. Set the A-B-C
switch to A, B or C. You must select
batteries in low temperature
conditions. Cold temperatures can
the same letter choice for both the
cause alkaline batteries to function
sensor and the companion unit (not
included) in order for the units to
synchronize.
improperly. Use lithium batteries in
the 5-in-1 sensor for temperatures
below -4ºF / -20ºC.
2
Install or Replace Batteries
3
Remove Rain Gauge Stabilizer
Batteries MUST be installed for
Locate and remove the rain gauge
this product to operate. AcuRite
stabilizer (plastic tab) taped into
recommends high quality alkaline
the bottom of the sensor. The rain
or lithium batteries for the best
gauge will not function until this is
product performance. Heavy duty
removed.
or rechargeable batteries are not
recommended.
A B C
1
A-B-C Switch
2
Install Batteries
4 AA Batteries
3
Rain Gauge Stabilizer
Remove and discard
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be
used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used
batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fre,
as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge
non-rechargeable batteries. DO NOT short-circuit the supply terminals.
3