Batteries must be installed into all three of the wireless sensors BEFORE
installing batteries into the main display unit. Use only fresh or new
batteries in all cases, and install correctly according to the polarity
( - & + ) symbols marked on the batteries and in the battery
compartments. We suggest using lithium batteries for better cold
weather performance. Do not mix old and new batteries.
INSTALL BATTERIES:
1. Twist and remove
larger bottom cone
section.
2. Remove the battery
door and set aside.
3. Install 2 “AA”
batteries into the
battery compartment.
4. Replace the battery
door and replace and
twist the bottom cone
section.
SECTION 2 • SETUP
Install Batteries
To allow for more than one weather station and wireless sensor
network to be used in close proximity, the main unit and all 3 wireless
sensors have a small switch labeled “A B C” near or in the battery
compartments. These switches are all factory preset into the same
position (either A, B, or C). This switch selects one of 3 wireless modes
to use, and all 4 switches in all 4 components MUST be set in matching
positions (either A, B, or C) for wireless communication to take place
successfully.
A/B/C Wireless Selection
Wireless Temperature & Humidity Sensor
- 3 -
- 2 -
SECTION 1 • OVERVIEW OF FEATURES
Outdoor
Temperature
Future
Weather
Forecast
Weather
Category
Display
Currently
Selected
Display
LOW & HIGH
History
Button
Operation
Buttons
Display
Button
Menu Button
Barometric
Pressure
Outdoor
Humidity
Rainfall
24 hour
Backlight
Button
Wind Speed
& Direction
Seasonal
heat index,
wind chill,
dew point
Indoor
Temperature
Indoor
Humidity
Atomic
Clock
Month & Date
Wireless Temperature
& Humidity Sensor
Wireless
Self-Emptying
Rain Collector
Wireless
Wind Sensor
Sends temperature,
humidity and atomic
clock signal to main unit
via a 433 mhz wireless
signal. This sensor
should be mounted
out of direct sunlight to
ensure accurate readings.
Powered by 2 “AA”
batteries.
Sends wind speed and
direction to main unit
via a 433 mhz wireless
signal. This sensor
should be mounted
high enough to accurately
record and transmit wind
information. Powered by 2
“AA” batteries.
Sends rain totals to main
unit via a 433 mhz
wireless signal.
Collection funnel is extra
wide for more accurate
rainfall totals. Foreign
debris should be cleaned
out of the collector funnel
regularly. Powered by 2
“AA” batteries.
REMOVE
BATTERY
DOOR
TWIST AND
REMOVE
BOTTOM CONE
About The Menu
This weather station features a menu that allows you to access basic and
advanced features. Press the “MENU” button to enter into MENU. Use
the UP and DOWN arrow buttons to scroll through the options. Press the
“OK” button to enter into a selected option in the menu. The display will
prompt you for further action. It is recommended that you explore
sections 4 and 5 to learn more about the menu options.
INSTALL
BATTERIES