background image

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN 

ENVIRONMENTALLY SAFE WAY AND IN ACCORDANCE WITH YOUR 

LOCAL LAWS AND REGULATIONS.

BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove battteries from equipment which is not to be 

used for an extended perid of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries 

properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries 

may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable 

batteries. DO NOT short-circuit the supply terminals.

 

TROUBLESHOOTING

Problem

Bad

Wireless Sensor

Reception

Display Console

Screen Not Working

No Wireless Sensor Data

(no communication)

Possible Solution

no bars

no bars and flashing

“ -- ” data

Relocate the main unit and/or the wireless 

sensor. Both units must be within 165 feet 

(50m) from each other. Make sure both units 

are placed at least 3 feet (.91 m) from other 

electronic appliances and devices that may 

interfere with the wireless communication 

(such as TVʼs, microwaves, computers etc). 

NOTE: It may take up to 20 minutes for the 

main unit to re-synchronize with the sensor 

when batteries are replaced. Use lithium 

batteries in sensor when temperature is 

below -4ºF (-20ºC).

If wireless reception is bad (no bars), see

“Bad Reception” section above. The wireless

ID setting on each unit must match for all

units to communicate properly. See “Set

Wireless ID” on the next page.

Make certain that the batteries are installed 

correctly.

Batteries may need replacing

6

5

Batteries: 4 x “AA” 

(not included)

Depending on home construction materials

Measurement Ranges

Outdoor Temperature: -40ºF to 158ºF

-40ºC to 70ºC

Indoor Temperature:   32ºF to 122ºF

0ºC to 50ºC

Outdoor Humidity:     1% to 99%

Indoor Humidity:          1% to 99%

Wireless Range: 165 ft / 

50 m MAX

Lithium Batteries Recommended in

Outdoor Sensor

 if temperatures are

below -4ºF

Please DO NOT return product to the retail store. 

For technical assistance and product return information, please call 

Customer Care:  

877-221-1252

w w w . a c u r i t e . c o m

Summary of Contents for 00609SBDIA1

Page 1: ...N WITH THE SALE OF ITS PRODUCTS FURTHERMORE NO PERSON FIRM OR CORPORATION IS AUTHORIZED TO MODIFY OR WAIVE THE TERMS OF THIS PARAGRAPH AND THE PRECEDING PARAGRAPH UNLESS DONE IN WRITING AND SIGNED BY A DULY AUTHORIZED AGENT OF CHANEY THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE For in warranty repair please contact Customer Care De...

Page 2: ...batteries in these low temperature conditions to ensure continued operation for wireless sensors placed outdoors NOTE Rechargeable batteries are not recommended due to higher operating voltages Installing Batteries Wireless Sensor Installing Batteries Display Unit Remove the battery compartment cover Install 2 fresh AA batteries as shown here BATTERIES MUST BE INSTALLED FOR THE SENSOR TO OPERATE R...

Page 3: ...sor is water resistant and is designed for general outdoor use However to extend the life of the product place the wireless sensor in an area protected from direct weather elements To ensure an accurate outdoor temperature measurement be sure the wireless sensor is placed out of direct sunlight and away from any heat sources There are 2 placement options for the wireless sensor You may hang it usi...

Page 4: ...or the wireless sensor Both units must be within 165 feet 50m from each other Make sure both units are placed at least 3 feet 91 m from other electronic appliances and devices that may interfere with the wireless communication such as TVʼs microwaves computers etc NOTE It may take up to 20 minutes for the main unit to re synchronize with the sensor when batteries are replaced Use lithium batteries...

Reviews: