Service Bulletin
19-054
October 8, 2019
Version 1
2020 NSX: TQI and New Model Information
AFFECTED VEHICLES
Year
Model
Trim
2020
NSX
ALL
INTRODUCTION
This bulletin covers the total quality inspection (TQI) of the 2020 NSX. It includes these procedures:
1. Install the Fuses
2. Remove the Center Console and Door Panel Protective Coverings
3. Release Shipping Mode
4. Fit Vehicle on a Lift
5. Inspect the Underbody
6. Check the 12-Volt Battery
7. Check the Brake Fluid Level, and Top Off the Windshield Washer Fluid
8. Make Sure the Trunk and Auto Pop Up Main Switches Are Set to ON
9. Make Sure Auto Pop Up and Smart Access Work
10. Check Trunk Operation
11. Check the Tire Repair Kit
12. Check the Tool Kit
13. Make Sure the Electric Parking Brake Works
14. Check the Wheel Bolt Torque
15. Set the Tire Pressures
16. Fuel the Vehicle
17. Initialize the TPMS
18. Check the Engine Oil Level on the Dry Sump Lubrication System
19. Check the PCM Idle Learn Procedure
20. Check/Refresh the SiriusXM
Radio Dealer Demo Service (Except Alaska and Hawaii)
21. Check the Voice System Interaction
22. Check the Integrated Dynamics System (IDS) Modes and the Automatic Brake Hold System
23. Install the Beverage Holders
24. Install the Front License Plate Holder (If Required) and Rear License Plate Hardware
25. Remove the Seat, Floor, Headliner, and Steering Wheel Protective Coverings
26. Install the Floor Mats
CLIENT INFORMATION:
The information in this bulletin is intended for use only by skilled technicians who have the proper tools, equipment, and
training to correctly and safely maintain your vehicle. These procedures should not be attempted by “do-it-yourselfers,” and you should not assume
this bulletin applies to your vehicle, or that your vehicle has the condition described. To determine whether this information applies, contact an
authorized Acura automobile dealer.
©
2019 American Honda Motor Co., Inc. — All Rights Reserved
Page
1
of
25
