Page
12
of
13
19.
Reset the AcuraLink Control Unit
When the No. 16 BACKUP (10 A) fuse is removed during vehicle shipping, the AcuraLink control unit sets DTCs.
You need to clear them during the TQI with this procedure:
NOTE: After installing the No. 16 fuse, wait at least
30 seconds
before doing this procedure.
1. Turn the ignition to ON.
2. On the navigation disclaimer screen, select
OK
.
3. Press and hold the BACK, MENU, and NAV buttons at the same time until the main diagnostic screen appears.
Then, select
Detail Information and Settings
.
4. Turn the interface dial to select
Diag CRM
, then press the ENTER button.
5. Turn the interface dial to select
Clear DTC Log
, then press the ENTER button.
6. Turn the interface dial to select
YES
, then press the ENTER button.
7. Select
OK
by pressing the ENTER button.
8. Turn the interface dial to select
Return
, then press the ENTER button.
9. Turn the interface dial again to select
Return
, then press the ENTER button. This returns you to the navigation
system screen.
20.
Set Up the Rear Entertainment System (If Equipped)
The rear entertainment system (RES) lets front seat passengers listen to one audio source through the speakers, while
the second and third row passengers watch a DVD or listen to a different audio source through wireless headphones.
There are also two audio jacks with individual volume controls at the back of the center console for wired headphones.
For more information, see the navigation manual.
To make sure the RES is working right, do this procedure:
1. Install the batteries into the wireless headphones. Each headphone uses one battery that you insert under the
cover of the left earpiece. To remove the battery cover, place a coin in the slot and twist it slightly. The remote
uses three BR3032 batteries that are already installed.
2. To use the headphones, pivot the earpieces outward to turn them on. When you remove the headphones, the
earpieces pivot inward and the headphones turn off. Store the headphones in the flat (off) position.
3. Turn the ignition to ACCESSORY or ON, then insert a DVD into the DVD player. Open the overhead screen by
pressing the OPEN button.
4. Adjust the volume with the dial on the headphone earpiece.
5. Repeat step 4 with the second set of wireless headphones.
NOTE: The wireless headphones work only from the second and third row seats. They do not work from the front seats
or outside the vehicle. Clients can order extra wireless headphones from your parts department.
