Page 2 of 4
SETTING THE CLOCK / TEMPERATURE MODE
. See
Figure 2
Press and hold the Clock button for approximately 2 seconds
until the hour display starts to flash (Remote must be in Auto
mode). Use the Up and Down buttons to set the hour. Pressing
the Clock button again will cause the minute display to flash.
Use the Up and Down buttons to set the minutes.
Press the Clock button a third time to activate the °F or °C
display. Use the Up and Down buttons to adjust for the desired
modes. To exit the setting mode, press the Clock button.
TRANSMITTER OPERATION:
WARNING:
IT TAKES SOME TIME FOR THE RECEIVER TO RESPOND TO THE TRANSMITTER. DO NOT PRESS
THE BUTTONS MORE THAN ONCE WITH 2 SECONDS FOR CORRECT OPERATION.
Fahrenheit or
Celsius display
CLOCK
button
TIMER
button
"UP" and "DOWN"
Buttons
PM
ROOM TEMP
SET TEMP
TIMER
C
F
F
C
Auto Mode
. See
Figure 3
Auto mode works like a thermostat,
turning the heater on and off to meet the
desired temperature.
TIMER OPERATION
. See
Figure 5
1. You can set the timer to the length of time you
want the fireplace to operate (1 to 120 minutes).
2. Press the TIMER button once. The Timer display
"---" will blink.
3. Press the Up and Down buttons to set the timer.
The LCD will display the time chosen.
4. The timer setting can be canceled at any time by
pressing and holding the "TIMER" button.
5. Press Manual or the Auto On/Off button to turn on
the fireplace.
6. The fireplace will turn off at the end of the timer
setting.
Manual Mode
. See
Figure 4
1. Press the Manual On/Off button once to light the fireplace. Push the
button again to turn it off.
2. In Manual mode the Remote Transmitter will not turn the fireplace
off/on even if the room temperature exceeds the target temperature.
CAUTION:
THE REMOTE RECEIVER WILL AUTOMATICALLY
TURN OFF THE FIREPLACE AFTER SIX HOURS OF
UNINTERRUPTED OPERATION. PRESS AUTO ON/OFF
BUTTON ON THE REMOTE TRANSMITTER TO RESET
THE REMOTE CONTROL, THEN PRESS AUTO ON/OFF
BUTTON AGAIN TO RESUME OPERATION.
1. Press the "TIMER" button
the "---" will start to flash.
2. Use the "UP" and "DOWN"
buttons to set the Time.
3. Press Manual or Auto On/Off
buttons to start the timer.
ROOM TEMP
SET TEMP
TIMER
C
F
F
C
MANUAL
button
AUTO ON/OFF
button
PM
ROOM TEMP
SET TEMP
TIMER
C
F
F
C
Fig 2
Fig 4
Fig 5
ROOM TEMP
SET TEMP
TIMER
C
F
F
C
Adjust set
Temperature
Thermostatic
Control
PM
