Acuity Brands | One Lithonia Way Conyers, GA 30012 Phone: 800.535.2465 www.acuitycontrols.com
© 2014-2016 Acuity Brands Lighting, Inc. All rights reserved. Rev. 06/06/16
nPODM-2P
2 of 2
WIRING
•
Mount WallPod using holes that align with standard single gang switch box or
low voltage ring.
•
Connect green screw to ground.
•
Access RJ-45 ports by sliding trapdoor up.
•
Insert CAT-5 cable(s) through opening and route out through cutouts in rear of
WallPod.
•
Secure cable(s) by sliding trapdoor back into orignal place
•
Interconnect unit with other nLight devices in lighting zone using CAT-5 cables.
•
Once power is received via CAT-5 connection, all devices in zone will
automatically begin functioning together according to each device’s defaults.
Power to WallPod device is provided via the CAT-5e connection to an nLight power pack/supply or Bridge. T568B pin/pair assignment is recommended for
all CAT-5e cables.
SLIDE
TO RJ-45 PORT
TO RJ-45 PORT
CA
T-5
CA
T-5
ON/OFF
TYPICAL WIRING
3-WAY CONFIGURATION WIRING
INSTALLATION
nPP16
LOAD 1
CAT-5
CAT-5
CAT-5C
AT-5
120 V
277 V
-
-
BLK
ORN
nPP16
120 V
277 V
-
-
BLK
ORN
GROUND
LOAD 2
nPP16
CAT-5
LOAD 1
CAT-5
CAT-5
120 V
277 V
-
-
BLK
ORN
nPP16
CAT-5
LOAD 2
120 V
277 V
-
-
BLK
ORN
CAT-5
GROUND
CAT-5
CAT-5
GROUND
CAT-5
LOAD 1
LOAD 2
Attention! Only use non-booted CAT5e cables.
