INSTALLATION INSTRUCTIONS
MLP165 MonoLine
®
“L” Wall Feed
MLP166 MonoLine
®
“T” Wall Feed
©2016 Acuity Brands Lighting, Inc. Printed in China Rev 7/11 P3201 pg 1 of 2
SAVE THESE INSTRUCTIONS and refer to them when making any additions or
changes to the track configuration.
IMPORTANT SAFETY INSTRUCTIONS
1. Read all instructions prior to installing this product.
2. Disconnect electrical power before adding to or changing the configuration of the track.
3. Do not install this track in damp or wet locations.
4. Do not install any part of track system less than 5 feet above floor.
5. Do not attempt to energize anything other than lighting fixtures and fittings intended for use on MonoLine track.
WARNING
BE SURE TO TURN OFF POWER TO THE JUNCTION BOX BEFORE INSTALLATION.
Note: Hang track from the
appropriate number of supports
before making Feed connection.
MLP165 “L” Wall Feed
MLP166 “T” Wall Feed
Make sure main power to system is OFF.
Remove Canopy Cover from bracket by
removing two Finger Nuts.
Connect Wall Feed wires to junction box
wires using wire nuts, black to black,
white to white.
Attach Mounting Strap to junction box
with enclosed screws. Make sure top
side of Wall Feed is facing up.
Reattach the Canopy Cover using Finger
Nuts. If necessary, loosen studs and
increase or decrease the stud length as
required.
Install cable support per instructions on
page 2.
Note polarity feature at bottom of opening
in Wall Feed Connector.
Note which side of track has a groove to
accept the polarity feature. The grooved
side of the track should face down.
Insert track fully into Wall Feed Connector
aligning polarity feature with groove.
Tighten all set screw(s) securely with the
hex wrench provided.
10
9
8
7
5
4
3
2
1
6
1300 South Wolf Road • Des Plaines, IL 60018 • www.junolightinggroup.com
