6. Firmware
Note: the 1.3.1 Uboot version shipped with the board is under constant
development. Currently there are a few limitations, which may be
resolved in future updates.
To use an USB keyboard under UBoot, it needs to be attached to the
upper external USB port (J18) or internal header J19A.
Uboot currently handles only 2 SATA ports from which you can boot.
It means that you must connect devices you want to boot from on J20
and J23 only.
Obviously, other devices will be recognised when the operating system
is loaded.
7. Instructions
There is a blue led near the J21 Sata connector. When this led is lit, the
board is under power. When the board is switched on, this led should
go off and the power led on the computer case should light on.
If you encounter a problem using your board, please contact your
dealer. He is very qualified to fix any issues.
8. Safety Information
ALWAYS DISCONNECT ALL POWER CABLES BEFORE CONNECTING OR
REMOVING CABLES FROM THE MOTHERBOARD.
Also make sure that your power supply is set to the correct voltage in
your area.
