Introduction | TURNPWR
Powering up
Turn on the power switch located on the door of the servo
cabinet
Turn the power switch on
1
(to the I position) on the console
which is located on the back of the control
Follow the builder’s instructions to turn on the machine
1
The start up screen with 3 soft keys will be displayed:
Shutdown
Find Home
Cancel
Press the
Find Home
or
Cancel
soft key
The default DRO screen will be displayed
It is strongly recommended that the control performs
the
Find Home
feature at start up, prior to any other
action taken.
If a program was loaded when the control was shut down, that
same program will be reloaded when the unit is powered up
again
If the control did not perform the
Find Home
feature at
start up:
Press the
Datum
soft key from the default DRO
screen to display the
Home
soft key
Press the
Home
soft key
The
Find Home
soft key will be displayed
2
ACU-RITE | TURNPWR | User's Manual | 08/2020
21
Summary of Contents for TURNPWR
