9
Troubleshooting
Problem
Possible Solution
No outdoor sensor
reception
no bars
If the wireless signal indicator shows no bars:
• Relocate the display and/or the outdoor sensor.
The units must be within 330 ft (100 m) of each other.
• Make sure both units are placed at least 3 feet (.9 m) away from
electronics that may interfere with the wireless communication
(such as TVs, microwaves, computers, etc.).
• Use standard alkaline batteries (or lithium batteries in sensor
when temperature is below -4˚F/-20˚C). Do not use heavy-
duty or rechargeable batteries.
NOTE:
It may take a few
minutes for display and sensor to synchronize after batteries
are replaced.
Outdoor
temperature
is flashing or
showing dashes
Flashing of the outdoor temperature is generally an indication of
wireless interference.
1. Bring both the sensor and display indoors and remove batteries from each.
2. Make sure the A-B-C switches on both units match.
3. Reinstall batteries in the outdoor sensor.
4. Reinstall batteries in the display.
5. Let the units sit within a couple feet of each other for a few
minutes to gain a strong connection.
Inaccurate forecast
• Weather Forecast icon predicts conditions for the next 12 to 24
hours, not current conditions.
• Has Learning Mode icon disappeared from the display?
Learning Mode must complete before forecast and pressure will
be accurate.
• Allow unit to run continuously for 33 days. Battery removal or
resetting the display will restart Learning Mode. After 14 days,
forecast should be fairly accurate, however Learning Mode
calibrates for a total of 33 days.
Inaccurate
temperature
or humidity
• Make sure both the display and sensor are placed out of direct
sunlight and away from any heat sources or vents (see page 6).
• Make sure both units are positioned away from moisture
sources (see page 6).
No rainfall
• Check that the batteries are installed correctly. Batteries may
need to be replaced.
• Reset the display by pressing and holding the RESET button,
located in the battery compartment of the display. Date and
time will need to be entered after a reset.
